HomeMy WebLinkAboutSign Plans192',
102' 6'5'
120"
\ø'ASPEN
TREE SERVICE
NEVIEWED FOR CODE COMT,å-IANCE
St'lìll:t"l -[O N() l li¡) I:\L I:l''l'IONS & INSI)t:('I l(: \s
GAR IìIEI,D COUNl'Y COMM I,()PMI,NT
r)A.r'n â-1-Æ-_ By
l{OINSI'í'r''l'ri'\ (''Y I !' |'l'lIIrqi' l'f \ ".'r(}NSI18
56{ h'rr}..c¡Þá,6n€ l2FAhÈÞ\\s+ årc ¡rn ¡ú_
Starr
ò
t545Ò
ffiú CqY
2.
3.
The sign identifies or advertises the legally-established use of the lot on
which the sign is located.
A sign shall be located upon the property or business identified or
advertised
1. Signs sha egress from any door, window, or
2
fire escape. No sign shall be attached to a standpipe or fire escape,
except those signs that may be required by other codes, regulations, or
ordinances for public safetY.
Signs shall have sufficient horizontal and vertical clearance from
authorized communication or energized electrical power lines as
prescribed by State law or as required by the utility provider.
No signs shall create an obstruction for traffic or create any hazard for
motorists, cyclists, or pedestrians, including:
a. Signs shall not impair visibility in the public right-of-way, or be
located within a Clear Vision Area in section 7-303.1.
b. Signs shall not obstruct or interfere with traffìc signs or signals.
They shall not imitate an official traffic sign or signal or contain the
words "stop," "sloW' or other similar words.
c. Signs shall not be of a size, location, movement, content, coloring,
or manner of illumination that may be confused with or construed
as a traffic-control device.
All signs shall be structurally safe, not hazardous, comply with the
Building and Electrical Code, and meet the following criteria:
a. Signs over 10 feet in height and/or 40 square feet in surface area
shall be engineered to withstand wind loading. Roof Signs, signs
mounted on marquees, or projecting signs shall be engineered in
such a manner that no guy wires are needed.
b. Electrical wiring for the sign shall be underground in the case of
Freestanding signs, and behind the sign cabinet in the case of
wall or projecting signs.
c. Anchors and supports shall be protected when near driveways,
parking lots, or similar locations where they could be damaged by
moving vehicles. Signs attached to masonry, concrete, or steel
shall be safely and securely fastened thereto by means of metal
anchors, bolts, or approved expansion screws of sufficient size
and anchorage to safely support the loads applied. No anchor or
suppo òf ány sigñ, exıèÞf flãt Wãll Si$ns, Shãll be connèctêd to
or supported by a parapet wall that is not braced
in
c.
3
4
All signs, excluding temporary decorative holiday lighting, shall have
shielded and covered light bulbs and shall not blink or flash.
llluminated signs shall not cause glare or otherwise adversely impact
residential areas.
The light from any sign illumination source shall not create a traffic hazard
1
2.
3.
sign is I ocated entirely on private property
to operators of motor vehicles.
a public right-of-way or easement
B. lllumination.
Gnnne¡-o Gou¡¡rv L¡¡¡o Use ¡¡¡o Developme¡¡r Cooe 714